check
check
check
check
Reasons and solutions for the laser ranging sensor to be stuck:
1. The surface of the laser ranging sensor is covered by dust, grease and other dirt, which affects the emission and reception of the laser, causing the sensor to measure inaccurately or even get stuck. To solve this problem, please refer to the following steps:
(1) Cut off the power supply to avoid personal injury or machine damage.
(2) Disassemble the sensor slowly according to the instruction manual.
(3) To clean the sensor, use a clean soft cloth dipped in a small amount of alcohol or detergent, and gently wipe the surface of the sensor. Be careful not to let the alcohol or detergent penetrate into the sensor.
(4) Assemble the sensor and confirm that the components are connected correctly and firmly.
2. Power supply problem, unstable plug-in or low battery power, you can check whether the power plug is damaged.
If the above methods still cannot solve the stuck problem, it is recommended to seek help from professional technicians.
